Product Description
Density of < 1,1 g/ml, this body filler and putty adheres to steel plates, zinced metal sheets, aluminium and GRP. Due to its creamy paste-like viscosity the Monofil Lightweight Filler enables a non-porous application and results in a smooth and sealed surface. Furthermore, it dries quickly and is easy to sand.
Ensure an adequate supply and exhaust air ventilation. Working temperature must be at least +10 °C. Max. air
humidity 80 %. Polyester-based body filler does not cure anymore at temperature of below +10 °C.
Color
White
Mixing Ratio
Paint + hardener 100:2 by weight
Processing conditions
Ensure an adequate supply and exhaust air ventilation. Working temperature must be at least +10 °C. Max. air humidity 80 %. Polyester-based body filler does not cure anymore at a temperature of below +10 °C.
Drying
Object temperature 20 °C Sandable after 30 minutes
Object temperature 60 °C Sandable after 10 minutes
Pot life at 20 °C
4 - 5 minutes
The substrate must be clean, dry and free from grease. Sand the surface slightly. Remove not cured old paint works and priming coats. Do not apply to thermoplastic or acidic products (wash-primer). Mix well the material with the hardener. Do not add more than 3% of hardener Hardener P! Underdosage or over-dosage of the hardener may lead to spotting in the finishing coat. Before each application clean and degrease the whole surface to be painted. De-rust completely damaged areas and dry sand with P 80/150 abrasive paper. After drying, dry sand with P 150/240. Before applying the filler dry sand with P240/360 to a matt surface. In order to fill nonferrous metals (e.g. aluminium, zinced surfaces), the surface can be primed with a suited epoxy-based primer to guarantee an optimum adhesion. Only dry sand putties.
